CVT Belt Replacement (Kawi Brute Force 750i)

Be A Brute!

Moderator: hemingray

User avatar
BruteForce
Knows UPS driver on a 1st name basis
Posts: 312
Joined: Fri Sep 28, 2007 8:21 pm
Location: South Jordan, Utah

Postby BruteForce » Wed Nov 26, 2008 5:46 pm

The Modfather wrote:Oh, i was asking cuz I have a few PDF manuals and happen to have one for the BF750 - was going to pass it along. In there, it should show you how to remove the primary sheave.

edit: and measure the deflection of the belt to let you know if it's too loose or too tight.
I bought the PDF manual on eBay a few months ago. Quite nice to have for quick reference.

User avatar
Elheffe24
Just realized teal ATV clothes are lame
Posts: 11
Joined: Mon Dec 10, 2007 5:19 am
Location: Volcano, Ca.

Postby Elheffe24 » Fri Nov 28, 2008 5:18 am

Hey BF your belt should not be tight at all you should be able to put a straight edge from the driven pully to the primary and with very little effort push down on the belt to get about 1 inch of deflection. Also from my experience stick with the Kawi belts the aftermarket stuff is junk. To get the primary clutch off you need a primary puller about 40.00 if you need one I can send you mine on loan. I am in a hurry this morning to get off to work but here is a good link on belt tightening deflection settings for the brute.
http://www.highlifter.com/forum/How_To_ ... 669/tm.htm
Good luck
2006 Brute Force 750, HMF Utility, Copperhead CDI, 26" Bighorns,


Who is online

Users browsing this forum: No registered users and 1 guest